veket用路由上网方法（其实很简单）

baticancer

用路由器上网最简单的了。

88484532

我使用的局域网+路由器上网方式,没有自动配置DHCP
使用静态IP,但一直不能上网

88484532

原帖由 88484532 于 2010-3-8 08:35 发表

                               
登录/注册后可看大图

我使用的局域网+路由器上网方式,没有自动配置DHCP
使用静态IP,但一直不能上网

在控制台打了几个命令,提示如下:
ip link
1: lo: <LOOPBACK,UP,10000> mtu 16436 qdisc noqueue
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,10000> mtu 1500 qdisc pfifo_fast qlen 1000
    link/ether 00:11:5b:85:81:ae brd ff:ff:ff:ff:ff:ff


ip route
10.50.9.0/24 dev eth0  src 10.50.9.252
default via 10.50.9.253 dev eth0


ip address
1: lo: <LOOPBACK,UP,10000> mtu 16436 qdisc noqueue
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
2: eth0: <BROADCAST,MULTICAST,UP,10000> mtu 1500 qdisc pfifo_fast qlen 1000
    link/ether 00:11:5b:85:81:ae brd ff:ff:ff:ff:ff:ff
    inet 10.50.9.252/24 brd 10.50.9.255 scope global eth0


请高手解决一下?

shimch

我的机子
ip link
1: lo: <LOOPBACK,UP,10000> mtu 16436 qdisc noqueue
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,10000> mtu 1500 qdisc pfifo_fast qlen 1000
    link/ether 00:10:5c:da:b5:3a brd ff:ff:ff:ff:ff:ff

iip route
10.16.56.0/22 dev eth0  src 10.16.59.95
default via 10.16.56.1 dev eth0

ip address
1: lo: <LOOPBACK,UP,10000> mtu 16436 qdisc noqueue
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
2: eth0: <BROADCAST,MULTICAST,UP,10000> mtu 1500 qdisc pfifo_fast qlen 1000
    link/ether 00:10:5c:da:b5:3a brd ff:ff:ff:ff:ff:ff
    inet 10.16.59.95/22 brd 10.16.59.255 scope global eth0

给你做做参考。

fnu1ipw

的确简单，用过一次就会了。